Novol ULTRA Glass Fiber Putty 800g High Strength Body Filler 0.8kg

NOVOL FIBER - Glass fiber reinforced putty. Thanks to special polyester resins and short glass fibers, the product has very good strength parameters combined with good elasticity. Soft and easy sanding ranks FIBER as the perfect choice for deeper dents and large surface areas. The putty adheres well to various substrates, including galvanized steel.

Colour:
Beige

Application life after mixing with the hardener: 4 to 8 mins at 20°C

Drying time: 20 to 30 mins at 20°C
The time can be reduced by holding for 10 minutes at maximum of 60°C

Substrates:

• old paint coatings,
• polyester laminates,
• steel,
• galvanized steel,
• aluminium,
• two-component acrylic primers,
• two-component epoxy primers.

Caution: Do not apply putty directly on wash primers, adhesion increasing agent, one- component acrylic products and NC products.
The putty adheres to most types of galvanised steel used today.

Procedure:
Mix the components well to get a uniform colour. Follow the required quantities of the hardener; it is recommended to dose by weight to obtain proper ratios of components. Apply with a putty knife in a layer that does not exceed 5 mm of thickness. It is advisable to level the surface of FIBER with other polyester putties before applying the next layer. The minimum application temperature is +10°C.

Surface preparation:

• old coatings: degrease, dry sand with P180 - P240 and degrease again;
• polyester laminates: degrease, dry sand with P80 - P120 and degrease again;
• steel surfaces: degrease, dry sand with P80 - P120 and degrease again;
• galvanized steel: degrease, mat with abrasive needled cloth and degrease again;
• aluminium surfaces: degrease, mat with abrasive needled cloth and degrease again;
• acrylic primer: degrease, dry sand with P180 - P240 and degrease again;
• epoxy primer: degrease, dry sand with P180 - P240 and degrease again;