BOLL Finish Putty 2X 3,6kg Polyester Grey Car VAN Body Filler Hardener

PROPERTIES:
A soft polyester putty for filling scratches and small cavities. Perfectly suitable for manual and mechanical grinding. Has great flexibility and very good adhesion to various types of surfaces.

COLOUR:
light grey

SURFACE:

• steel - primed, sand, blow off and degrease with „BOLL Silicon remover”, and then apply another coat.
• aluminium - primed, sand, blow off and degrease with „BOLL Silicon remover”, and then apply another coat.
• old paint coating - sand with P320 – P400, blow off, degrease with „BOLL Silicon remover”, and then apply another coat.
• epoxy primer - can be used to isolate materials. Sand with P320, blow off, degrease with „BOLL Silicon remover”, and then apply another coat.
• two-component acrylic primer - sand with P320 - P400 blow off, degrease with „BOLL Silicon remover”, and then apply another coat.
• polyester laminates - sand with P80-P120, blow off, degrease with „BOLL Silicon remover”, and then apply another coat.

INFORMATION:
Putty should not be applied directly to reactive primers (wash primers), one-component acrylic and nitrocellulose products.

PHYSICAL PROPERTIES:

• Density at 20°C: 1,70 – 1,90 g/cm
• Solubility in water: very weak
• Viscosity: 210 000 – 370 000 mPa*s
• VOC content: less than 250 g/l (acceptable 250g/l)
• Temperature of use: +10°C – +25°C

CLEANING:
Wash immediately after application with nitrocellulose thinner or thinner for acrylic products.

STORAGE CONDITIONS:
Protect the product from excessive low and high temperatures. Avoid direct exposure to sunlight. Store in dry places.

SHELF LIFE:
Two years from the date placed on the package.

OTHER INFORMATION:
All technical data are approximate values. We advise you to test the material to ensure its suitability for a specific application. The producer reserves the right to improve the product and change the technical conditions with the possibility of making changes inside the specifications.